Menu List

The menu list shows the available pages displayed six at a time.  To access the list, press the Esc key.  Depending upon where you are starting from, it may require pressing this button more than once.  The up (é) and down (ê) arrows are used to scroll through the selections, which are repeated below.  To go to a specific page, either type in the page number and press Enter, or use the arrow keys to highlight your selection and then press Enter.

 

    Operator Level – No Pass Code Required

1. IR STATUS DISPLAY

2. IR OVERALL STATUS DISPLAY

3. O2 DISPLAY

4. PUMP CONTROL

5. SET DISPLAY VALUES

6. HELP

7. CALIBRATION DATES

8. LANGUAGE / LENGUA

9. BATTERY STATUS

10. ABOUT / SIGN-ON

11. REVISION DISPLAY

12. LOGGED DATA START DATE

13. LOGGED DATA DISPLAY

14. SESSION

15. SAMPLING PARAMETERS

 

Supervisor Level – Level 1 Pass Code Required

16. SET THE DATE AND TIME

17. PORT SETUP

18. ZERO CALIBRATION

19. O2 CELL CALIBRATION

20. COMMUNICATIONS SETUP

 

Configuration Level – Level 2 Pass Code Required

22. CALIBRATE FLOW METER

23. CALCULATION FACTORS

24. SPAN CALIBRATION

25. SET PASS CODES

26. SET IP ADDRESS

27. OPTIONAL CELL CALIBRATE

28. GENERAL INFORMATION

 

 

Page 21 is reserved for future use and does not exist at this time. To minimize the possibility of unintended modifications to the instrument, certain menu pages will require the entry of a pass code to access them.  Pages 1 through 15 are Operator level screens that do not require any security codes.  Pages 16 - 20 are Supervisor screens requiring a level 1 pass code (default = 1).  Pages 22 – 26 are Configuration screens requiring a Level 2 pass code (default = 2).

 

At the bottom of the Menu Screen is a status bar.  This tells the current date and time, and also displays the internal temperature (IT) of the instrument.  This internal temperature should never exceed 50